The LOOP/ENV is a Voltage controllable and very flexible ADSR module. It’s based around the Electric Druid LOOPENV1 PIC, which is a digital clone of CEM 3312 / SSM 2056. It offers CV Control over the envelopes complete time, Positive, Negative and Bi-Polar Outputs. It is switchable between Linear and Exponential curves and can either be used as a traditional ADSR or in LOOP mode can function like an LFO (the different outputs come in very handy here especially the +/-), it can also go well up into the audio range in this mode. The Envelope is “snappier than a piranha jacuzzi” minimum envelope times of 1MS through to long envelope times and everything in between.
3 modes (On/OFF/ON toggle):
– Toggle up = VCADSR
– Toggle middle = Gated looping (will only loop when there is a gate present)
– Toggle down = Looping , ie VCLFO
How the looping works:
– Sustain set to zero – cycles through the Attack and Decay only, the Release then sets the ‘off time’ – very cool.
– Sustain set higher than zero but lower than maximum – cycles through Attack and Decay until the Decay reaches the Sustain level, then it goes into Release. There are some superb weird waveforms to be had here.
– Sustain set to maximum – cycles though Attack and Release only. Decay sets the ‘on time’ ie how long it holds high after Attack but before Release.
Power req: +12V 30mA /-12V 20mA
Attack, Decay, Release min/max: 1ms – 10s (per segment)
Max freq in loop mode 310Hz
Max triggering speed 950Hz